On October 8, 2021, in order to prevent the saw blade from swinging from side to side when the wire Fret saw motor is sawing, a saw clip is installed under and above the table. The lower saw clip is directly installed under the working table, and the upper saw clip is installed on the machine body. Up, you can move up and down. There is a pulley behind the upper saw card. When the saw blade runs backward, it acts as a restriction and prevents the saw blade from falling. The machine tool adopts the method of intensively discharging sawdust to ensure the cleanliness of the work place. The CNC band saw is generally operated by a computer. When sawing larger workpieces, two people should be equipped to work together up and down. When performing straight-line sawing, hold the workpiece firmly with your hands, close to the saw ratio, and advance horizontally. Long materials can be slightly lifted by the operator so that the rear end of the workpiece is not lower than the table surface. The feeding speed should be appropriately controlled according to the nature of the material and the size of the workpiece, and it is forbidden to push, pull, and hit the saw blade. When the worker crosses the saw back 200mm, he can start pulling. When the rear end of the workpiece is close to 200 mm of the saw tooth, you should release your hand when you get started, and pull the workpiece by the lower object to finish the sawing. When the wire saw motor saw blade does not reach the corresponding high speed after driving, do not feed the workpiece to avoid sudden increase of the motor load.
Post time: Oct-08-2021